Location -> News
News
Pump Selection for Honey: Why Small Flow Duties Need Their Own Model
Honey transfer projects often involve multiple duties with different flow rates. Reusing one pump model seems convenient, but it can lead to poor performance when flow ranges vary widely. Here is a case in point.
Two Honey Duties
Parameter Duty 1 Duty 2
Medium Honey Honey
Flow rate 500 L/H 0.3–0.6 m³/h
Viscosity 3000 cP 1000–1800 cP
Motor Standard Standard
Duty 1 uses a CYB1.6-2y rotary lobe pump: 25 mm ports, 304 SS wetted parts, 1.1 kW VFD motor, 140 rpm.
Duty 2 should not use the same pump. A small-flow magnetic drive pump, size 12.0, is the better fit.
The Reason: Flow Range, Not Viscosity
Duty 2 has lower viscosity, which makes the honey easier to move. The real issue is its small flow range — only 0.3–0.6 m³/h, compared with the CYB1.6-2y's 1.6 m³/h maximum.
Speed too low: Flow in a rotary lobe pump is proportional to speed. To reach 0.3 m³/h on a 1.6 m³/h pump, speed must fall below about 30 rpm. At that speed, pulsation increases and flow becomes less stable.
More internal slip: Rotor clearances in a large pump suit higher displacement. At low speed and small flow, recirculation takes a larger share of output, so actual flow may fall short.
Right-sized alternative: A magnetic drive pump size 12.0 is designed for small-flow, medium-viscosity service. It handles 1000–5000 cP and meters 0.3–0.6 m³/h more accurately than a large lobe pump running at minimum speed.
Conclusion
Duty 2's limiting factor is flow rate, not viscosity. The CYB1.6-2y already covers Duty 1 well, so Duty 2 deserves its own small-displacement magnetic drive pump with VFD or servo control.
Always match pump displacement to the required flow first. Then check viscosity and materials. An oversized pump does not save money — it costs stability, accuracy, and dependable output.
Last:没有了 Next:Upgrade Your MAG-ACLV-8427 Pump..










